MT frugal tech tip

First if you are not familiar with reloading or guns and ammo just purchase the blank from the website. This is for frugal shooters that probably have some old or tarnished brass shells laying around. Just take your time, don’t be in a hurry and bring out the die grinder. Just remember when arming the trip wire device to point it down, even though the shot is gone the plastic wad will still come out like a bat out of hell. Have fun with your new toy😊

Directions:

  1. Cut the top of the crimp away from the shell
  2. Empty out the BB
  3. Cut through the shell and wad with curved pruning shears. I picked some writing on each shell, so they are uniform.
  4. I pulled the wad out and flipped it, so the edge is not so ratty, not necessary.
  5. Since you cut the sealing crimp away you need to seal the shell. I just used a ratty opened tube of calk I found in the basement, probably could use superglue to seal.
  6. That’s it, not rocket science, just take your time and remember to keep flames and sparks away from powder if you are a dumb ass.
  7. A PEX plastic plumbing pipe cutter will probably work

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *